|
|
Home » News » industry information » A brief discussion on the function of single power amplifier output - film capacitance

A brief discussion on the function of single power amplifier output - film capacitance

Views: 1     Author: Site Editor     Publish Time: 2020-02-10      Origin: Site

A capacitor is a metal foil electrode that is superimposed on a plastic film such as poly (ethyl ester), polypropylene, polystyrene, or polycarbonate. According to the type of film can be divided into poly (ethyl ester) capacitor, polypropylene capacitor, polystyrene capacitor, and polycarbonate capacitor. So what is the function of a single power supply op amp output connected to a thin film capacitor? Below small make up and everybody talk about.

 

Op amplifier single power supply refers to the fact that op amplifier only USES one power supply, such as DC 5V, DC 12V, single power supply, only one voltage is output. For example, the input waveform is changed, and the output is only changed in the positive voltage waveform. Level before and after the main function is to look at the circuit and the connection mode of judging, and capacitance value, also be the basis of judgment is very important, in general if you are a single op-amp up into one and a half wave rectification, then the output capacitance to ground, usually as a low pass filter, holds the half-wave rectifier of the steamed bread wave filter into dc, if output string of a capacitor, differential.

 

Taking advantage of the fact that the voltage at both ends of the capacitor can not be mutated, the single-op amplifier outputs only the upper half or the lower half of the signal into the lower half of the ac signal, which is generally referred to as the pass-through intersection. The purpose of the waveform is that the latter stage needs to use positive and negative ac signals. Thin-film capacitors are used in a wide variety of op amp circuits, both at the output and input ends. If a signal is connected at the same time, it is usually filtered (such as a low-pass filter). If it is connected in series, the function can only be known by looking at the back circuit (such as high pass filtering, etc.).

 

After reading this article, do you have an understanding of the function of the single-power opamp output connected to the thin film capacitor? If you have any technical questions, please contact us and we will try our best to solve them for you.


Links

Contact Us

> Tel:86-562-2821018
> Fax:86-562-2821558
> Mob:86-13305620368
> Email:mpp@film-capacitor.com
> Address:NO.1771 QiFeng Road, Shizishan Economic Development Zone,Tongling, Anhui, China
Copyright  2017 Anhui Safe Electronics Co., LTD. All rights reserved. Sitemap      Log in to my mailbox