The connection of individual compensation capacitors should be done: for induction motors started directly or through a rheostat, the capacitors that improve the power factor can be directly connected to the output terminals of the motors. Do not install switchgear or fuses between the two; For indu

Before the capacitor is installed, it is necessary to allocate the primary capacitance to balance the phase between the capacitors, and the deviation does not exceed 5% of the total capacity. When the relay protection device is installed, the balance current error should not exceed that of the relay

When a capacitor with a lower voltage grade runs in series in a higher voltage grade network, the insulators corresponding to the operating voltage grade shall be installed between the shells of each station to the ground, so that it can be reliably insulated. After the capacitor is connected by sta

When installing capacitors, it is best to connect each capacitor with a separate soft wire and not with a hard busbar, so as to prevent damage to the capacitor casing caused by assembly stress and damage of oil leakage caused by sealing. Any bad contact in the capacitor circuit may cause high freque