a. Used capacitors can no longer be used, but can be removed as a periodic inspection to test electrical performance; b. If the capacitor is charged, discharge it with a resistor of about 1kΩ before use; c. If the capacitor is stored under conditions of more than 35 ° C and humidity greater than 70%

Capacitors used within the rated performance range specified in the product design specification shall be avoided for use in the following situations when confirming the use and installation environment: a. high temperature (temperature exceeds the maximum use temperature); b. Overcurrent (current e

6.The connection of individual compensation capacitors should be done: for induction motors that start directly or through a rheostat, the capacity of the power factor can be connected directly to the output terminals of the motor, and between the two. Three single-phase capacitors are adopted. Each

1.When the capacitor is installed, the wiring of each capacitor is best connected with the bus bar, and the hard busbar connection is not used in order to prevent the assembly stress to cause the damage of the capacitor bushing and destroy the oil leakage caused by the seal. 2.Any undesirable contac