|
|
| Français
Home » News » industry information » Failure analysis of film capacitors and introduction of solutions

Failure analysis of film capacitors and introduction of solutions

Views:2     Author:Site Editor     Publish Time: 2021-02-05      Origin:Site

The frequency of use of film capacitors is relatively high, and they are mainly used for cross-connection of analog signals and other power sources. It has many excellent features and is an excellent capacitor product.

 

Capacitor failure:

Capacitor breakdown, open circuit, lead break, insulation rupture and other failures that make the capacitor completely incapable of working are fatal failures. Other failures will make the capacitor unable to meet the requirements of use and gradually transition to fatal failure; the capacitor is under working stress and environment Under the combined action of stress, certain failure modes will occur separately or simultaneously after working for a period of time. The same failure mode has multiple failure mechanisms, and the same failure mechanism can produce multiple failure modes. The relationship between failure mode and failure mechanism is not one-to-one.

 

Failure analysis of film capacitors:

The film capacitor is used in the diode absorption circuit, the rated voltage of the capacitor is 630VDC, and the normal peak in the circuit is less than 200V, which meets the derating requirement. The appearance of the failed capacitor is good, and there is no trace of damage with the LCR long test. The failed samples have no capacity, and the pins are in an open state. The capacitor plastic package is unlocked. The lead and the lead are welded well to the gold sprayed layer. The gold sprayed layer and the core are connected Traces of blackening; unfold the metalized film of the capacitor core, and the metalized film of some failed capacitors is bright and smooth, and the other. Part of the metalized film has been heated and deformed. The preliminary judgment is that the excessive dv/dt of the circuit causes the capacitor to fail. The voltage waveform in the test circuit found that the dv/dt is 3000V/us, but the maximum dv/dt of the selected film capacitor is only 40V/μs. In order to verify the failure mode, take a batch of new capacitors, and the initial test is normal. After the machine is aging, 80-90% of the capacitors fail. Eliminate the quality problems of the manufacturer's incoming materials and determine that the capacitor is not suitable for use in the circuit.

 

Solution:

All single boards (including semi-finished products, finished products and shipped products" The capacitor used in this position is replaced with a double-sided metalized polypropylene container with a higher specification dv/dt and the problem is solved.

For film capacitors, in addition to voltage and capacity, the most important parameters for selecting absorption capacitors are dv/dt and ripple current (voltage). Especially the dv/dt parameter, even for capacitors with the same capacity and voltage, different series, and different pin spacing, the rated value can range from a few V/us to a few KV/us. If the capacitor is only selected from the voltage and capacity indicators, the capacitance I will attenuate and disappear after a period of time. In addition, because the switching frequency of power devices is relatively high (up to hundreds of KHz), small voltage fluctuations at high frequencies will lead to relatively high ripple currents (I=WCU), and excessive ripple currents will cause heart capacity temperature Open high, parameter deterioration or burnout.


Links

Contact Us

> Tel:86-562-2821018
> Fax:86-562-2821558
> Mob:86-13305620368
> Email:mpp@film-capacitor.com
> Address:NO.1771 QiFeng Road, Shizishan Economic Development Zone,Tongling, Anhui, China
Copyright  2017 Anhui Safe Electronics Co., LTD. All rights reserved. Sitemap      Log in to my mailbox